Dec 01, 2022 Leave a message

Installation Guide for LED Light Strip

1. Indoor installation: When LED light strips are used for indoor decoration, they do not have to withstand wind and rain, so the installation is very simple. Take the LED light strip produced by Guanghong Electronics as an example. Each LED light strip has a self adhesive 3M double-sided adhesive tape on the back. During installation, you can directly remove the sticker on the surface of the 3M double-sided adhesive tape, then fix the light strip at the place where it needs to be installed, and press it flat with your hand. As for some places where corners are needed or long, what should we do? It is very simple. The LED light strip is a circuit structure composed of three LEDs in series and parallel. Every three LEDs can be cut off and used separately.

2. Outdoor installation. Where cutting and connection are required, the method is the same as that for indoor installation, except that waterproof glue is additionally provided to consolidate the waterproof effect of the connection point.

3. Power supply connection method: The LED light strip generally has a DC 12V voltage, so it needs to use the switching power supply. The power supply size depends on the power and connection length of the LED light strip. If you do not want each LED light strip to be controlled by a power supply, you can purchase a high power switching power supply as the main power supply, and then connect all the input power supplies of LED light strips in parallel (if the wire size is not enough, it can be extended separately), and uniformly use the main switching power supply for power supply. The advantage of this is that it can be centrally controlled. The inconvenient place is that it is not possible to achieve the lighting effect and switch control of a single LED light strip. The specific method can be measured by yourself.

4. Controller connection mode: LED racing light belt and RGB full-color light belt need to use a controller to achieve variable effects, and the control distance of each controller is different. Generally speaking, the control distance of simple controller is 10 to 15 meters, and the control distance of remote controller is 15 to 20 meters, and the maximum distance can be 30 meters. If the connection distance of the LED light strip is long, and the controller cannot control that long light strip, then the power amplifier needs to be used for tapping.

5. Note the connection distance of LED light strips: Generally speaking, the maximum connection distance of 3528 series LED light strips is 20 meters, and the maximum connection distance of 5050 series LED light strips is 15 meters. If the connection distance is exceeded, the LED light strip is easy to heat up, which will affect the service life of the LED light strip during use. Therefore, the installation must be carried out according to the requirements of the manufacturer, and the LED lamp must not be overloaded.


Send Inquiry

whatsapp

Phone

E-mail

Inquiry